Network DTCs(Diagnostic Trouble Codes)(U-codes) may have been set during programming. It’s going to write the VIN number and recording data… If the configuration goes good, we should be done. PTS(Technical Resource Center) Homepage or Enter numbers: 013A Manual entry will provide multiple screen for the entry of configuration data which can be obtained from the Configuration database. You have 2 options for entering the Configuration data into the module. The service tool was unable to obtain configuration data from the original module.Ĭonfiguration data will be used to configure the module. OK > OK (Keep ignition OFF during the process) Programming > Programmable Module Installation > PSCM Have been identified vehicle model, go to To avoid IM608 scanner from pulling out wrong information which is loaded in there right now.

Turn ignition off, because the new module is actually installed on the vehicle already.

It should be very fast because I ever did other modules and had to enter all of these manually one by one. Locate “Power Steering Control Module”, luckily we have only one section to fill which is 013A.It’ll show book data that are belong to this VIN number. Go to to select country & language, click Free Resources > Quick Guide > Module Build Data(As-Built) > Enter VIN number of vehicle, submit.Let’s go to find this as built data on the server.

We need to get the information online, and push it into this module. Following I’ll show how to program power steering control module with Autel MaxiIM IM608 Scanner without using the software of manufacturer. I have to find the information or as built data and push it into the new module. The original module is not available at the moment. I had a power steering control module swap on this vehicle – 2013 Ford Mustang GT with 5.0 liter v8 engine.

Ford as built data country code